Wait for about 15 minutes and deflate the tire to the recommended pressure. Then inflate to a pressure that is 10-15 kPa above the value recommended on the tire placard. When you are ready to inflate your tires, first make sure they are cold. And double check that tires are worn out when the TPMS light shows a low pressure condition.
Autel not allowing scn coding manual#
Look for the recommended pressure in your vehicle owner’s manual or the tire placard attached to the door edge.
Please always keep the correct air pressure in your specific tires.
My TPMS light comes on and my vehicle tells “please check tire pressure” and “a low pressure condition”. Sensors or your vehicle need a certain while to get back to their parking status before a second relearn. Please wait for at least 15 minutes before you start a second relearn, otherwise it may cause a failure. Too fast or too slow speed may cause a relearn failure. We suggest that your driving speed is controlled between 25 km/h and 100 km/h throughout the relearn. I are performing an auto relearn as required, but still get failed. In that case, if you try an auto relearn, you may get failed. For example, TS601 requires Autel sensors are programmed into the 2015 Renault Megan 3 model in an OBD relearn process. Any operations inconsistent with the instruction will lead to the failure. Please strictly follow the step-by-step instructions in Relearn Procedure in your Autel tool. I cannot access and complete the sensor relearn. If TPMS troubles codes are found, or if you cannot complete the relearn after installing Autel sensors even you stick to the step-by-step relearn procedures, repair or replace the damaged parts based on the failure causes you find. Then relearn new sensors into your vehicle by strictly following our advised relearn procedures. If any unusual value, replace the damaged sensors with Autel sensors. Please use an Autel tool to check both sensor information and control modules. What do I do?Ī collided vehicle may have either broken tire pressure control modules or broken sensors or even both.
Repair or replace worn-out parts, for example a transmitter, receiver or sensor. Please use an Autel tool to detect TPMS trouble codes and confirm failure causes. Probably it’s the tire pressure control modules that are worn out due to a too long service. PS: contact Autel Technical Support at email TPMS parts related problemsĪ 2005 or older vehicle model has an illuminated TPMS light. One –by one Autel MaxiTPMS Question and Answer: If you have the same problems, please proceed to read it.Ģ. Following are 12 pieces of frequently asked TPMS related Problems and Solutions collected by AutelTechnicians.
0 kommentar(er)
